If pin 2 of Q1 is at 44V then pin 2 of Q2 should also be at 44V…if not then Q2 isn’t making good connection to the circuit, which could cause these symptoms. You might want to re-flow your intern’s solder joints for good measure.
Note the voltages on the picture in this post:
https://zeppelindesignlabs.com/forums/topic/setting-the-bias-current-scratchy-cortado/#post-2156
Are there any other voltages that aren’t matching up to the voltages on this picture?
Good luck. Let me know.
-Brach