After extensive fiddling I got it to show continuity from the square pad for the LED to pin 6; I mustve just destroyed the solder pads when I desoldered the original LED. I havent gotten the other pad to show connection to the resistor yet but I’m sure the same thing happened there.
1) It shows between 0 and 0.002, and the continuity function of my meter says its continuous.
2) 4V across the LED every time I press the bypass switch. I just realized that one of the toggles makes it momentary so when I was done with all the testing I pushed the toggle the other way and tried everything again to make sure it was in the right position.
3) Desoldered the hookup wires connecting the LED to pin 6 and the resistor; same result. Just tested the LED again by touching one wire to ground and the other to Pin 5, it strobed in time with the tap tempo LED.
(Yes, I’m aware the tap tempo switch isnt connected. It kept coming off as I turned the board from front to back so I figured I’d just solder it a final time once I fix it).