Hi Brach, thanks again for the comprehensive pics etc, very helpful. So I’ve cut the traces fine, and am just about to do the jumpers, the one from R4 to the pin on U2-TL074 is fine, but the one from C11 to C15 is a little more tricky, access to that solder joint on C15 is quite restricted by the cap itself on the component side of the board and by the ‘Harmonic Mix’ pot on the other side, I’d prefer if possible not to unsolder the pot. So I’m wondering if it’d be possible to run that jumper from C11 to C10 instead as there’s a direct trace between the required lead on C15 to C10 and that solder joint is far easier to reach. Electronically I can’t think why this wouldn’t work but I wanted to check, I may be misunderstanding it.
Many thanks
Ben