Cleaned everything up, touched all the questionable solder joints to make sure they werent cold. Still no luck. I thought that may have been what you meant with question 2 so I had already checked that too just in case. After cleaning I Got a reading of 5V a couple times and got excited for a second, but I think I may have slipped over to pin 7. Now its still at 4v and wont change with the bypass switch.also, thanks for the advice on the solder, the stuff im using is definitely too thick.
I checked the bypass switch again, making sure the contacts were only continuous when the switch was pressed.
What did you mean by cut the trace to pin 6?